SNR modeling and material dependency test of a low-cost and simple to fabricate 3D force sensor for soft robotics

Abstract

This paper presents a low cost, easy to produce, small tactile sensor system, that can be embedded in a soft material and limited space. In the current implementation, we use a Hall-effect sensor and a magnet to measure the force. One sensor module can measure 3D force vector and temperature. This chip is planted inside a 55 × 55 × 8 mm of the silicon layer. The module has I2C digital output, requiring only four wires for each module. The experiment shows that the signal to noise ratio (SNR) for this module is relatively high, 21.4658 dB when 20g load is applied. The experiment also indicates that the sensor module measured loads differently depending on the type of material that is in contact.