首页 /研究 /Pressure and Angle Sensors with Optical Fiber for Instrumentation of the PrHand Hand Prosthesis
OTHER

Pressure and Angle Sensors with Optical Fiber for Instrumentation of the PrHand Hand Prosthesis

Laura De Arco, María José Pontes, Marcelo Eduardo Viera Segatto, Maxwell E. Monteiro, Carlos A. Cifuentes, Camilo A. R. Díaz

发表年份
2022
引用次数
4
访问权限
开放获取

摘要

Abstract The principal cause of upper limb amputations is due to traumatism. The prosthesis is an assistive device to help in the activities of daily for the amputee person. However, one of the latest reports shows that in developing countries there are around 30 million people without assistive devices. This work presents the development of two kinds of sensors for the PrHand, an upper limb prosthesis based on compliant mechanism and soft-robotics. The sensors are made with polymeric optical fiber (POF), due to their flexibility and low cost, and the working principle is based on intensity variation. The angle sensors are used for monitoring the interphalangeal joint of the fingers, and for the assessment were made cycles of closing and opening each finger. On the other hand, the force sensors are located at the tip of three fingers to track the force made over the objects. Before encoring the sensors were evaluated making five cycles of compressing and decompressing each sensor. The results show a linear behavior between the angle and the voltage variation, one most remarkable angle sensor result was with a sensibility of 0.0357 V/° and an R 2 of 99 % closing and 0.0483 V/° opening. In the case of the force sensor, a polynomial relation was found between the voltage changes and the pressure over the sensor; in some cases, the relation between voltage changes and pressure could be linear but that depends on the construction of the sensor. Regarding the obtained R 2 of 99 %, its sensibility was 0.0361 V/N compression and 0.0368 V/N decompression. In conclusion, was successfully developed two kinds of sensors for the instrumentation of PrHand prosthesis. It is expected to use angle and sensor variables as input in algorithms of Machine Learning to improve the detection of objects. One aspect to improve is to control in a better way the sensor construction parameters due to the considerable influence over the sensor behavior.

关键词

Closing (real estate)Flexibility (engineering)Pressure sensorVoltageAcousticsComputer scienceSimulationEngineeringElectrical engineeringMechanical engineering

相关论文

查看 OTHER 分类全部论文